Step 7: Fix the tabletop boards
Fix the tabletop boards to the upper frame in the same manner as the seat boards were fixed to the lower frame in steps 5 and 6.
Once the outside run of boards is fixed in place and the rest of the boards have been cut, lay them in place, row by row.
Use wedges or packers between the gaps if necessary, to help position and hold the boards in place until nailed.
Step 8: Drill the umbrella hole
Turn the tabletop unit upside down.
Drill a hole through an innermost tabletop board as close as possible to the junction where the spokes join.
Use a 40mm (or there about) drill bit, but check your umbrella first, just in case it has a larger than normal diameter pole.
Do not drill all the way through - drill just until the point of the drill breaks slightly through the board.
You can complete the hole from the other side when the table is turned upright.
Drilling through both sides should help prevent the possibility of tearing around the edges of the hole.
Step 9: Add temporary spacers
The purpose of the spacer blocks are to hold the upper and lower frames apart at the correct distance until such time as the
legs can be fixed in place.
The upper frame is currently sitting on the ground in the upside-down position.
According to the plans, the distance between the upper frame and lower frame is 230mm.
Therefore the spacer blocks will need to be 230mm long.
Cut six spacer blocks 230mm long out of 145mm x 45mm wood.
Temporarily nail the spacer blocks to the ends of the upper frame (tabletop) spokes.