|
|
|
Step 18:
More than likely you will have to cut the end pieces to make them fit.
You can then nail all the back-rest pieces [k] and [l] to the back-rest rails [j].
Use 30mm (1 1/4") galvanized nails, pre-drill the holes into the back-rest pieces [k] and [l] and set (punch) the heads of the nails into the wood.
|
Step 19:
Fit the back-rest unit in place between the top of the two rear legs [b].
Position the back-rest unit (height-wise) according to the plan
or according to your taste.
Secure with two 90mm (3 1/2") screws at each meeting.
Pre-drill the screw holes through the rear legs [b].
|
|
NOTE: This complete plan-set can be purchased in downloadable PDF format with more pictures free of advertising and print friendly for only $5. For more info
click here
|
Step 20:
Cut, shape and glue and screw the arm-rest supports [m] in place.
Refer to the plan for placement.
Use two 50mm (2") screws for each piece and pre-dill the arm-rest supports [m] first.
|
Step 21:
Add the arm-rests after first applying a bit of glue.
Nail the arm-rests to the arm-rest supports with 50mm (2") galvanized nails. Pre-drill the nail holes in the arm-rests and set (punch)
the heads of the nails into the wood.
|
Step 22:
Now just cut a few boards [o] to go into the base of the boot box, and that's about it.
There is no need to nail any of the base boards [o] as they can just sit there on top of the wood strips [f].
|
Post comments about this project via the contact us page.
User comments and/or photos
No comments about this project so far
Read people's comments about other projects in the site click here
To see other people's photos of various projects
click here
|
|
|
|
|
Copyright © Buildeazy.Com Ltd. All rights reserved. Reproduction of any material
in this website is strictly prohibited without expressed written permission from the owner.
|
|
|
Page five: The arm-rest
-
User Comments/Photos