Assemble the easel
1)
Measure and cut all the pieces of wood to the lengths given in the easel pieces on the previous page.
2)
Drill 6mm (1/4') holes in the pieces of wood. The positions of the holes are given in
easel piece drawings
3)
Lay the top piece on the ground. Place the two front legs and the front vertical piece on the top piece and align the holes.
4)
Insert the appropriate bolts into the holes. Lift the unit slightly off the ground so that washers and nuts can be applied
to the bolts and then tighten the nuts finger-tight.
5)
Place the front horizontal piece on the front legs and front vertical piece as shown in the picture.
6)
Insert the appropriate bolts into the holes. Lift the unit slightly off the ground so that washers and nuts can be applied
to the bolts and then tighten the nuts finger-tight.
7)
Turn the unit over and tighten the nuts with a spanner.
|
Page two: Assemble the easel
Add the rear leg