# Building a Police Box   a.k.a.The Doctor's TARDIS

### Step 1. Cut the frame pieces to length

Cut the frame pieces to the lengths as given in the tables below. There is both a metric table followed by a standard (ft and inch) table.

#### Metric measurements (standard table next page)

FOR STOCK SIZE LENGTH QTY
base border frame 90 mm x 90 mm 1430 mm 4
[A] pillar 90 mm x 90 mm 2175 mm 4
base middle joist 90 mm x 45 mm 1250 mm 1
[B2] pillar 140 mm x 45 mm 2275 mm 4
[B] pillar 190 mm x 45 mm 2275 mm 4
[G] infill 190 mm x 45 mm 1030 mm 4
[C] pillar 90 mm x 35 mm 2175 mm 8
[H] middle head side 140 mm x 35 mm 1210 mm 4
[J] upper head side 140 mm x 35 mm 1140 mm 4
[E] sign holder 190 mm x 35 mm 1230 mm 4
[F] lower head side 190 mm x 35 mm 1280 mm 4
floor boards 150 mm x 25 mm 1370 mm 10

Note: There are discrepancies between the metric table on the previous page and the standard (ft and inch) table on this page. There is good reason for that, so use one or the other but do not mix and match - i.e., stick to either the metric system or the standard system throughout the project.
Some stock sizes vary between the two. Puzzled? For further explanation, go to the 'Explanations' page.

#### Standard measurements (metric table previous page)

FOR STOCK SIZE LENGTH QTY
base border frame 3½" X 3½" 57¼" 4
[A] pillar 3½" X 3½" 87" 4
base middle joist 1½" X 3½" 50¼" 1
[B2] pillar 1½" X 5½" 91" 4
[B] pillar 1½" X 7½" 91" 4
[G] infill 1½" X 7½" 41¾" 4
[C] pillar 1½" X 3½" 87" 8
[H] middle head side 1½" X 5½" 48¾" 4
[J] upper head side 1½" X 5½" 45¾" 4
[E] sign holder 1½" X 7½" 49¼" 4
[F] lower head side 1½" X 7½" 51¾" 4
floor boards 1" X 6" 54¾" 10