|
|
|
Step 7. Make the throne seat
Run 1"x 1" seat board supports [j] around the inside of the seat area, and fix with glue and 1 1/2" wood screws.
First glue and screw the front seat board support [j] to the inside of the seat front rail [c], 1" down from the top.
Then glue and screw the back seat board support [j] to the inside of the seat rear rail [c], 2" down from the top.
Next, glue and screw the side seat board supports [j] to the insides of the seat side rails [d], aligning them with the front and back seat board supports.
Next, cut the 1" x 6" seat boards [k] to length and glue them in place on top of the seat board supports [j].
The last board will need to be ripped down (cut lengthwise) in order to fit.
|
Step 8. Make the throne base
Chamfer (angle/bevel) one edge of 1 1/2" x 3 1/2" stock [h,i] for the base.
Measure (allowing for miter cuts) and cut the front and rear base pieces [h] and the two side base pieces [i].
Bolt the two side pieces [i] to the bottom of the legs, and glue and screw the front and rear base pieces [h] to them.
Next, screw 1" x 1" base board support around the inside of the base pieces [h,i] 1" down from the top.
Cut the 1" x 6" base boards [k] to length and glue them in place on top of the base board supports [j].
You will have to cut around the legs and rip the last board in order for it to fit.
|
|
|
|
|
|
Copyright © Buildeazy.Com Ltd. All rights reserved. Reproduction of any material
in this website is strictly prohibited without expressed written permission from the owner.
|
|
|
Page five: Instructions - The Seat and Base