1: Introduction, overview
2: Wood sizes, Angles, Material list
3: Plans: Side elevation, Legs, Spoke pieces
4: Plans: Spoke cutting detail
5: Plans: Table and seat board cutting detail
6: Cut the spokes to length
7: Shape the ends of the spokes
8: Assemble the spokes
9: Cut the tabletop and seat boards
10: Fix some seat boards
11: Fix the rest of the seat boards
12: Fix the tabletop boards
13: Align the upper and lower frames
14: Cut and fix the legs to the spokes
15: Drop in the umbrella
16: User Photo/Comments
● See the video at YouTube
Step 11: Cut and fix the legs to the spokes
Cut six legs out of 1 1/2" x 5 1/2" stock to the dimensions given in the drawing below.
Fix the legs to the spokes using the pictures below for guidance.
The pictures below are pretty much self explanatory.
Picture 1. The dimensions, with the table upside-down.
Picture 2. Mark where the legs are to go. Refer to Picture 1. for placement.
Picture 3. Clamp the legs in place.
Picture 4. Drill the holes for the bolts.
Picture 5. Put in the bolts, add a washer per bolt, tighten the nuts, and take off the clamps.
Picture 6. Cut six strips of 3/4" plywood about 4" wide by 11 1/2" long. Then glue and screw them to the underside of the seat boards for added strength.