Table of Contents
The floor, roof and A 100×50 (2×4) vertical framing member used to construct walls. layout plans
Fig.1 – Floor layout
The floor layout plan below gives the overall Any of the three linear measurements, length, breadth and depth. of the floor frame.
The floor frame is constructed of 100×100 (4×4) skids [a] and 100×50 (2×4) joists [b] and end joists [c].
All floor frame Any of the framing wood. should be Pressure treated. Refers to lumber that is treated in such a way that the sealer is forced into the pores of the wood. Refers to lumber pressure sprayed with chemicals to lengthen its life expectancy for outside use or inground applications. or otherwise suitable for exterior use.
Individual Piece of lumber that is part of a frame or structure. lengths are given in the Parts List.
Fig.2 – Roof layout
The shed roof layout plan below gives a birds-eye view of the roof frame layout.
The members shown in the roof frame plan are the side wall top plates [g], the front and rear wall Running parallel with the slope of the roof at the gable. top plates [l], the middle rafters [z] and the The horizontal line at the top of opposing sloping sides of a roof running parallel with the building length. Blocks, see Block. [n].
All the members in the roof frame are 100×50 (2×4) stock.
Individual member lengths are given in the Parts List and drawings showing individual member lengths and angle cuts are in the Front and Roof plans.
Fig.3 – Stud layout
The shed stud layout plan gives a birds-eye view of the wall stud layout.
More detail, placement measurements as well as individual member lengths and angle cuts are shown in the Front and Roof plans, and the Rear and Side plans.