How to build an 8ft x 10ft Storage Shed
Add the hinges to the horizontal rails on the door and then 'hang' the door in place by fastening the loose ends of the hinges to the casing (trim) surrounding the door opening.
Fixing the hinges to the casing allows the door to open 180°
Adding the door stop
Fix 50mm x 25mm (1" x 2") wood (door stop) to the jamb around the inside perimeter (sides and top) of the door to cover the gap between the door edge and the jamb.
Do not fix the door stop tight against the door on the hinged side. A little bit of play is needed to ensure the edge of the door does not bind against the door stop when the door is being opened or closed. See fig.2 and fig.3.
Adding a drip cap
A drip cap is a horizontal piece of molding that is fixed above the door to deflect any water from running inside.
This can be shaped from 75mm x 25mm (1" x 3") stock and fixed to the casing directly above the door. See fig.3 and fig.4.
Done! Install a Window and you're done!
Final note. Wind: It is presumed that this shed will be tucked away in a sheltered part of the back yard without any real concern about the wind, and because it is a heavy and solid structure, it is highly unlikely that it is going to blow away under normal conditions. However..... If the shed is situated in a windy area and there are concerns, then additional securing measures should be taken. The shed will need to be fastened against uplift.
1.) Concrete a pile or post into the ground under each corner of the shed and fasten to the bottom plate with a metal strap or similar type of fastener.
2.) At each corner fasten the bottom plate to the stud with a metal strap or similar type of fastener.
3.) At each corner fasten the stud to the top plate with a metal strap or similar type of fastener.