Table of Contents
The plans show a flat plan “bird’s-eye view” and an Side view of a building. (side) plan giving all Any of the three linear measurements, length, breadth and depth.. Refer to these plans for any required measurements throughout the project.
The A roof that covers a driveway or other parking area, it does not have a door in the manner of a garage. A garage for one or two cars consisting of a flat roof supported on poles. is a 6000 Abbreviation for millimeter which is a metric unit of length equal to one thousandth of a meter. 25.4 mm equals one inch. x 3000mm (20ft x 10ft) Four-sided figure with four right angles..
Mark out the four corners, and erect Timber, lumber. The hard fibrous lignified substance under the bark of trees profile boards (Profiles;Horizontal boards attached level to stakes, used to mark out the boundary of a construction and establish the levels and building line.) out from each corner and also out from the middle to take in the two center posts. How much the teeth are angled out on a circular saw blade. the profile boards (batter boards) back at least 600mm (2ft) from the The outline of a building. (carport boundary.) to allow room for hole digging etc.
For instructions on setting the profiles go to here
The building line (in this case) is the perimeter of the carport (the very outside edge). It is a 6000 mm x 3000mm (20ft x 10ft) rectangle.
The posts however, will need to be off-set in from the building line, 50mm (2″) in from the sides and 300mm (12″) back from each end (front and back).
Use string lines (attached to the batter boards) to make a rectangle that will determine the see PILE positions.
As mentioned, the posts will be off-set 50mm (2″) in from the sides of the building line, and 300mm (12″) back from the ends (front and back) of the building line, thus, the A slightly elastic string stretched between two pegs and used as a guide line. Determines the building line. should form a rectangle 5400mm x 2900mm (18ft x 9ft-8in).