Easy Bench Seat

Description
An easy to make Bench Seat PDF downloadable file
Easy to build a Bench Seat
There are 17 pages in the downloadable file, including plans, drawings, photos, and step-by-step instructions.
Easy: This is a good project for the beginner woodworker or DIYer.
Few tools are required. The whole project can be cut out with a handsaw.

Most of the cuts are square-cut – pretty easy, – although there are a couple of angle-cuts required,
but printable angle patterns are included in this instructions.
Simply print them out, fold along the lines and use them to mark the angles.
There is also easy step-by-step instructions with plenty of drawings and photos
The plans are written in both standard (inch) and metric (millimetre) measurements.

There are only two stock sizes used. Ex 1″x3″ (25mm x 75mm) and ex 1-1/2″x 3″ (38mm x 75mm)

You will also need:
Around one hundred 2″ (50mm) exterior type wood screws, four 3/8″ (10mm) galvanized carriage/coach bolts 3″ (75mm) long, exterior type wood glue, wood preservative (if required).

And tools…
You can get way with just a handsaw, electric drill and drill bits for the bolts and screws, a hammer, square, screw driver, measuring tape, pencil, a bit of sand paper, and that’s about it.