Table of Contents
Wood you will need
Section 7:
Section 7.1. Wood for the bed base
ITEM | FOR | STOCK SIZE | LENGTH | QTY |
[a] | side rail | ¾” x 3½” (90 mm x 19 mm) | 63″ (1575 mm) | 2 |
[b] | bed slat support | ¾” x 1½” (38 mm x 19 mm) | 63″ (1575 mm) | 2 |
[c] | bed slat | ¾” x 3½” (90 mm x 19 mm) | 27″ (675 mm) | 12 |
In all you will need:
6 lengths of ¾” x 3½” (90 mm x 19 mm) @ 8ft (2400mm) long.
Note: The above amount allows for wastage, and includes item [b] which can be ripped out of ¾” x 3½” (90 mm x 19 mm) stock.
Section 7.2. Wood for the body panels
All the body (sides, front, and back) can be cut from 1 ¼ standard 8ft (2400mm) x 4ft (1200mm) sheets of 3/4″ (18mm) custom MDF board.
You will also need an assortment of screws, nails, glue, along with paint and any other knick-knacks you might want to add.
This racing car bed was made by Roger from a buildeazy plan.
The plans can be seen here https://www.buildeazy.com/kids-racing-car-bed/
Roger says
Hi
Attached photo of my bed to your design. Made slightly wider so I could use Ikea slats for base.
Many thanks – great fun.
Hope Grandson likes it!
Regards
Roger D Stonham
Eastleigh, UK