Table of Contents
This page has three drawings. Scroll down to see them all.
(1). Firstly, the plan with all the Any of the three linear measurements, length, breadth and depth..
(2). Secondly, a drawing of all the parts also showing where to drill the screw holes.
(3). Thirdly, a drawing showing how to make the curved shapes.
[a] Back A piece of sawn, or dressed lumber of greater width than thickness. Usually 19mm (3/4") to 38mm (1 1/2") thick and 75mm (3") or more wide.
[b] Front board
[c] End Plumb, upright. members also showing the positions of the screw holes
[d] Intermediate vertical members
[e] Bottom upper Parallel to the horizon, flat, level. Piece of lumber that is part of a frame or structure. also showing the positions of the screw holes
[f] Bottom lower horizontal member
The curved shapes
Below is a drawing explaining how to make the curved shapes. Plates and cups can be used as patterns.