|
How to make a set of retaining garden steps
|
4) Prepare the ground behind the tread
Dig back at least 100mm (4") behind the tread.
Dig, pack, and/or fill and tamp until that the ground is firm and level with the top of the tread.
|
5) Position the next riser
Place the next riser on top of the firm and level ground directly behind the tread.
|
6) Cut and fit the side boards
Cut the side boards out of 150mm x 50mm (2" x 6") treated lumber.
Measure, mark and cut the first board on each side so that the top
of each board is level with the top of the
uppermost riser.
Then cut the ends of the side boards flush with the retaining wall post as shown in the picture.
Next measure, mark and cut another piece of 150mm x 50mm (2" x 6") treated lumber to fill the gap
between the bottom of the previously fitted side board and the ground.
|
|
Page three: The second step riser and the sides