Table of Contents
- 2The parts and cutting list
- 3Step 1 & 2. Cut the pieces and drill the side boards
- 4Step 3. Mark position for the first side board
- 5Step 4. Fix the first side board
- 6Step 5 & 6. Add and fix the remaining side boards
- 7Step 7. Prepare the table top and seat top
- 8Step 8. Clamp the sides to the tops
- 9Step 9. Add the braces
Step 4. To secure with nails or screws. the first side A piece of sawn, or dressed lumber of greater width than thickness. Usually 19mm (3/4") to 38mm (1 1/2") thick and 75mm (3") or more wide.
Screw a side board WITH ONE SCREW ONLY TOP & BOTTOM to the table top The top and bottom frame member of a door or window (not the jamb). Cross member of panel doors or of a sash. Also the upper and lower member of a balustrade or staircase extending from one vertical support, such as a post, to another. The horizontal member of a fence. and the footer.
Ensure the board is Being even with. with the top of the top rail and flush with the bottom of the footer.
Screw a side board WITH ONE SCREW ONLY TOP & BOTTOM to the seat top rail and the footer.
Ensure the board is flush with the top of the top rail and flush with the bottom of the footer.
THE REASON to put only one screw in (top and bottom) at this stage, is so the assembly can be skewed, if need be to make it square.
Now check with a set-square that the assemblies are square and that the top rails and footers are Being of equal distance from each other at all points..