Table of Contents
Instructions – Steps 1 to 2
Step 1. Cut all the members
Cut out all the members (pieces) to the Any of the three linear measurements, length, breadth and depth. as shown in The cutting list, on page 3.
Step 2. Mark and lay out the palings
Measure 40mm (1 1/2″) down from the top and the same amount up from the bottom of all 14 palings (a) and mark a line. Also mark corresponding lines on the 2 extended palings (b), making a total of 16 marked boards altogether. Lay all the palings (a) and extended palings (b) next to one another on an even surface, with the bottoms against a straight edge to keep them in line. When laying down, ensure that there are 7 palings (a) in between the 2 extended palings (b). (See diagram below.)
Note: The gap measurements are given on the next page.