Go to Buildeazy Home Page color break
   
Home   
Contents   

Custom Search

 
Free woodworking
Plans & Projects
free woodworking plans and projects
Your photos of buildeazy d.i.y. projects
Subscribe to be notified of new projects
Copyright © Buildeazy.Com Ltd.

Guide to building a Shell only
Single Garage
page:   1   2   3   4   5   6   7   8   9
  10   11   12   13   14   15

Page 6:Detail


[a]  

Footing 300 [1ft] square x 450 [18"] deep

[m]  

Purlin 75 x 50 [2x3]
[b]   Post/pile can be 100x100 [4x4] or 125x125 [5x5]. Treated for in-ground applications. [o]   Ribbon plate 50x50 [2x2] fixed against wall frame to take sprockets
[c]   Bottom plate / wall plate / sole plate [p]   Sprocket 75x40 [1-1/2x3]. Member from wall to fascia to support soffit
[d]   Stud. 100x50 [2x4] upright wall frame member [s]   Soffit. 4.5 [1/4"] thick under eave cover
[i]   Ridge board 150x25 [1x6] [w]   Roofing iron
[j]   Rafter 100x50 [2x4] [y]   Exterior wall cladding
[k]   Ceiling joist 200x50 [2x8] spans the width of the garage and is fixed to the rafters [fa]   Fascia board 150x25 [1x6]
[l]  

Cleat 100x50 [2x4] goes directly under ridge board and fixed to rafters

  


Click on a hyperlink below to go to that page.

CONTENTS
bullet Page 1: Introduction
bullet Page 2: Identifying the parts
bullet Page 3: Flat plan
bullet Page 4: The wall frames
bullet Page 5: The roof
bullet Page 6: Detail
bullet Page 7: The eaves
bullet Page 8: The exterior cladding
bullet Page 9: The roof cladding
bullet Page 10: The angle cuts
bullet Page 11: Bracing and fastening
bullet Page 12: Materials list
bullet Page 13: Cutting list
bullet Page 14: Glossary of terms
bullet Page 15: A guide to building the garage

<<< Previous page     Next page >>>



   
Copyright © Buildeazy.Com Ltd. All rights reserved. Reproduction of any material
in this website is strictly prohibited without expressed written permission from the owner.
Custom Search