Table of Contents
The materials list and cutting list
The Materials list
Below is the shopping list. It would pay to add a bit extra to the Timber, lumber. The hard fibrous lignified substance under the bark of trees tally to allow for any wastage.
It does not matter whether the wood you use is Rough sawn; Not gauged, planed or dressed. (rough) or Surfaced; planed; smooth; even surface; gauged. (smooth), as long as it is suitable for outside use.
When cutting the lengths, always cut the longest lengths first to minimize waste.
|50mm x 25mm (1″ x 2″) stock||handles and legs||3.3m (11ft)|
|150mm x 25mm (1″ x 6″) stock||tray and wheel||5.2m (17ft)|
|50mm (2″) stainless steel screws||tray and legs||40 of|
|approximately 25mm (1″) diameter round wood, pipe or similar||axle||225mm (9″)|
|saddle clips or U bolts||fixing axle to support The top and bottom frame member of a door or window (not the jamb). Cross member of panel doors or of a sash. Also the upper and lower member of a balustrade or staircase extending from one vertical support, such as a post, to another. The horizontal member of a fence.||2 of|
Cutting the pieces
Cut all the pieces to the lengths given below and then refer to the plan drawings on the following page for the shape Any of the three linear measurements, length, breadth and depth. – and then cut (shape) the pieces accordingly.
All the pieces can be cut from 50mm x 25mm (1″ x 2″) and 150mm x 25mm (1″ x 6″) boards.
Cut the following to the given lengths:
[A] From 50mm x 25mm (1″ x 2″) stock, cut 2 pieces 1175mm (47″) long for the handle/support rail pieces.
[D] From 50mm x 25mm (1″ x 2″) stock, cut 2 pieces 400mm (16″) long for the legs.
[B] From 150mm x 25mm (1″ x 6″) stock, cut 2 pieces 450mm (18″) long for the end tray panels.
[C] From 150mm x 25mm (1″ x 6″) stock, cut 2 pieces 513mm 20 1/2″ long for the side tray panels.
[E] From 150mm x 25mm (1″ x 6″) stock, cut 3 pieces 400mm (16″) long for the tray base,
and from 150mm x 25mm (1″ x 6″) stock, cut 6 pieces 300mm (12″) long for the wheel.
Then mark and cut (shape) the pieces as shown in the plan drawings on the following page.