Table of Contents
Step 1. Making the tray base
Place the two handle/support rails [A] on an even surface so that the front ends (axle end) are 75mm (3″) apart (or a width that is slightly more than the thickness of the wheel), and the handle ends are 400mm (16″) apart overall.
The tray base is made out of three 150mm x 25mm (1″ x 6″) boards [E] that are 400mm (16″) long.
Place the three tray base boards [E] side-by-side on top of the two handle/support rails [A], forming a Four-sided figure with four right angles. 400mm (16″) x 450mm (18″).
Refer to the plan drawing for position and To secure with nails or screws. them to the handle/support rails [A] with 50mm (2″) stainless steel screws.
Step 2. Fixing the tray side panels
The ends of all the tray side and end panels have been cut 15 degrees A line across the face of a piece of wood (at right angles to the length) is a square line. A line deviating from the square line is off square. Off-square refers to how many degrees the off square line is in relation to the square line. For example, a line at a 5 degrees angle to the square line, is 5 degrees off square..
Screw the end panels [B] to the side panels [C]with 50mm (2″) stainless steel screws, but pre-drill the holes first through the end panels [B].
The side panels [C] sit on the tray base, but the end panels [B] sit on the two handle/support rails [A], up against the tray base.
See the picture for reference.