Go to Buildeazy Home Page color break

Custom Search

Free woodworking
Plans & Projects
free woodworking plans and projects
Your photos of buildeazy d.i.y. projects
Subscribe to be notified of new projects
Copyright © Buildeazy.Com Ltd.

Guide to building a Shell only
Single Garage
page:   1   2   3   4   5   6   7   8   9
  10   11   12   13   14   15
Page 9:The roof cladding

garage roof schematics
garage roof detail

Roof nailing Fix the roofing iron to the purlins (m) with appropriate roofing nails/screws. Fix to the top and bottom purlins at every second corrugation and fix to the intermediate purlins at every 3rd or 4th corrugation. Fix through the high side of the corrugation.
Roof overhang Overhang the roofing approx 65 (2 1/2") past the fascia board (fa) or 50 (2") past the back of the gutter.
Ridge flashing Usually standard about 130 (5") each side of the apex but can vary and any size can be made to order. Have the ridge flashing in mind when positioning the top purlin. Fix to the purlin at every second corrugation.
Barge flashing The barge flashing goes under the ridge flashing at the top. Fix to each purlin (through two corrugations) and also to the barge board (ba).

Click on a hyperlink below to go to that page.

bullet Page 1: Introduction
bullet Page 2: Identifying the parts
bullet Page 3: Flat plan
bullet Page 4: The wall frames
bullet Page 5: The roof
bullet Page 6: Detail
bullet Page 7: The eaves
bullet Page 8: The exterior cladding
bullet Page 9: The roof cladding
bullet Page 10: The angle cuts
bullet Page 11: Bracing and fastening
bullet Page 12: Materials list
bullet Page 13: Cutting list
bullet Page 14: Glossary of terms
bullet Page 15: A guide to building the garage

<<< Previous page     Next page >>>

Copyright © Buildeazy.Com Ltd. All rights reserved. Reproduction of any material
in this website is strictly prohibited without expressed written permission from the owner.
Custom Search