Table of Contents
- 2Wood and Wood Size
- 3The Plan drawings
- 4Material requirements
- 5Step 1. Commence cutting the frame pieces
- 6Step 2. Cut and make the back top
- 7Step 3: Make the side frames
- 8Step 4. Rebate the back legs
- 9Step 5. Assemble the frame
- 10Step 6. Make the king chair seat
- 11Step 7. Make the king chair base
- 12Step 8. The final touches
Step 3: Make the side frames
Lay the front legs [a], back legs [b] and the side seat rails [d] loosely in place on a flat surface. Refer to the plan on page 3 for position.
Mark the screw holes in the front legs [a] and the back legs [b].
Take the front legs [a] and the back legs [b] and drill the screw holes.
Refer to the fixing method diagram below for drilling and screwing detail.
Once the screw holes are drilled, lay the front legs [a], back legs [b] and the side seat rails [d] in place again on a flat surface.
Cut a spacer piece an inch (25mm) shorter than the side seat rail [d] and place it between the bottom of the legs.
Why an inch (25mm) shorter?
Because the front and back legs are not Being of equal distance from each other at all points.. The back leg is tilted 3°.
Next glue and clamp the legs to the side seat rails and then add the screws.
Shape and fit the arms.
Shape and cut the arms according to the plan below. There are two options.
Once shaped and cut, To secure with nails or screws. the arms [g] to the front legs [a] and back legs [b] with glue and screws.