Table of Contents
1.) The arbor posts
Dig four holes 14″ (350mm) square by 24″ (600mm) deep.
Position the holes as shown in the arbor plan (Page 2). Concrete the posts in place and wait until the concrete cures (usually the next day) before cutting the tops of the posts to the required height.
For a detailed description of how to position the posts, mix and pour the concrete, and cut the top of the posts (including the rebate), go to here,
and although it is for a different arbour, the method is the same.
2.) Cut and trench the arbor beams
Mark and trench (checkout, rebate) the two beams. The dimensions are shown in the Arbor plan (Page 2).
This can be achieved by setting the blade on a circular saw to the required depth and making repeated saw cuts across the beam where the trench is to go. Finish by chiseling out the grooves with a sharp chisel. The more saw cuts, the easier the chiseling.
3.) Position the arbor beams
Bolt the beams to the top of the posts with 12mm (1/2″) galvanized coach/carriage bolts. Use two bolts at each meeting, eight in all. (See picture.)