|
6.
|
Add the table and seat members
First fix the seat members [k] and [l] to the appropriate seat supports [k] and [l] ensuring frame is square, level and plumb.
The placement of the seats along support members is crucial. Study the dimensions shown in fig 2.a (in the downloadable plans).
Because the placement of this seat is important, it is advisable to hold it in place with only one screw each end of each member, until the folding motion has been tried as a slight adjustment may be required.
Next screw the tabletop in place. Ensure it starts 10mm (3/8") in from the rear of the tabletop support, horizontal member [g]. See fig 2.c (in the downloadable plans). Also ensure that the overhang at each end of the table side frames are equal.
All seat and tabletop members should be pre-drilled and screwed with two screws at each meeting.
|
Brace the rear seat
