Build an Adirondack chair By Les Kenny[Table of contents are below]
Step 5. Add the bottom rail
In this context, the bottom rail is a piece shaped specifically to give the back boards their curved profile.
The bottom of the back boards are fixed to the bottom rail.
The bottom rail is fixed on top of the rear spreader.
Apply some glue and center the bottom rail top of the rear spreader, with the back edge of the bottom rail flush with the back of the rear spreader.
Hold it in place with a clamp and fix it with screws.
TABLE OF CONTENTS
Page 01 Measurements, Materials list, required tools, the wood, The parts
Page 02 Cutting all the pieces to length
Page 03 Cutting the seat slats
Page 04 Cutting the back boards
Page 05 Shaping the sides
Page 06 Marking the seat curve
Page 07 Marking the seat curve (photos)
Page 08 Marking, cutting, the middle rail
Page 09 Marking and cutting the bottom rail, the arms, and corbel
Page 11 Adding the bottom rail
Page 12 Adding the legs, props, and corbels
Page 13 Adding the arms and middle rail to the mix
Page 14 Adding the back boards
Page 15 Preparing and adding the seat slats
Page 16 Shaping the back
Page 17 Photos. Touch up and sand
Page 18 Photo. Not a bad chair eh?
• User Comments/photos