color break
    
k2 red telephone box
[< Previous]   [Contents]   [Next >]
How I made my K2 Telephone Box
Author: Les Kenny; Editor: Maree Anderson
Recommend

video

plans for the telephone box neck Step 3.1. The neck - making the box unit

Note: The plan image is scaled to fit in the page.
For a clearer view click on the plan image and it will open in another window where the measurements will be more legible.

Although some plans are shown at appropriate stages throughout the course of these instructions, the plans are also in a complete group in Chapter eight.

The rails

Out of ¾" (19mm) thick boards I ripped (cut lengthwise) two different size strips, 1 1/8;" (28mm) for the top rails and 1 3/8" (35mm) for the bottom rails.
I ripped enough of each size to allow for the following:

For the top rails I cut 2 @ 34¼" (856mm) and 2 @ 32¾" (820mm).
For the bottom rails, the same - 2 @ 34¼" (856mm) and 2 @ 32¾" (820mm).

Purchase this plan in downloadable PDF file for $5.00 here

The plans (68 pages) can be purchased online and immediately downloaded to your computer. Purchase here.

View all downloadable plans here

The corner posts

I cut four pieces of 2½" x 2½" (62mm x 62mm) wood to the length of 8¼" (206mm).

telephone box neck-frame Making up the box unit

I lay two corner posts apart 32¾" (820mm) overall and fixed the top rail to the top and the bottom rail to the bottom, creating an oblong frame 32¾" (820mm) x 8¼" (206mm). Then I made another, two in all.

I stood the above two frames on end and fixed the other appropriate rails (top and bottom) as per picture.

Recommend