One piece folding Bench and Picnic Table
Identifying the pieces
[a] front leg
[b] rear leg (inner)
[c] rear leg (outer)
[c1] back stop
[d] lower seat rail (rear)
[e] seat rail (rear)
[f] leg extension part 1 (rear)
[f1] leg extension part 2 (rear)
[g] table rail
|
[h] seat rail (front)
[h1] seat rail brace (front)
[i] arm rail
[i1] arm rail brace
[j] arm pad
[k] seat board (front)
[l] seat board (rear)
[m] tabletop board
[n] seat brace (rear)
|
Tools you will need
• Circular power saw,
• Drop saw (chop saw) - able to cut accurate angles,
• Jigsaw,
• hacksaw,
• Electric drill,
• Hammer, Hand saw, Measuring tape, pencil, square, screw driver, level,
• 10 mm (⅜") drill bit for the bolt holes,
• 3 mm (⅛") drill bit for the screw holes,
• 22 mm (⅞") drill bit to countersink (embed) the bolt head. The bit must be a larger diameter than the bolt head.
Note: You can purchase this plan in downloadable PDF file, print friendly and in clean copy (free of ads) for only $5.00.
Click here to purchase.
The plans can be purchased online and immediately downloaded to your computer.
To view all available $5 downloadable plans
click here