Go to Buildeazy Home Page color break
   
Home   
Contents   

Custom Search

 
How to build an
Old Style Park Bench
park bench seat
How to build an
Old Style Park Bench - ft and inch version
See video
For the metric (mm) version visit our sister website here
PAGE CONTENTS
bullet Page 1: introduction and material list
bullet Page 2: Plans - the individual pieces
bullet Page 3: Plans - elevations and details
bullet Page 4: Instructions - making the legs
bullet Page 5: Instructions - making the arms
bullet Page 6: Instructions - the cut-outs
bullet Page 7: Instructions - back and front assembly
arrow Page 8: Instructions - seat boards and braces
bullet Page 9: Instructions - arms and back infill
bullet Page 10: User Photo/Comments
the seat boards Step 11: Fit the seat boards

Screw a seat support along the front rail 1 1/4" down from the top.

Measure between the front and rear rails, to determine the length of the seat boards. They should be approximately 20 1/2" long.
Cut the seat boards out of 1 1/2" x 5 1/2" wood.

You will need 9 boards. One may need to be ripped down in order to fit.

Cut the seat boards and fit them, but first apply a run of glue along the seat supports.
Fix by way of screwing from underneath - through the seat supports into the seat boards.

bench braces fixed in place Step 12: Fit the shaped braces

Fix the shaped braces under the side rails against the front and rear legs.

Glue and nail them.

bracing detail

Once the shaped braces have been fixed in place, you can take off the holding clamps.

<<< Previous page  |  Next page >>>


   
Copyright © Buildeazy.Com Ltd. All rights reserved. Reproduction of any material
in this website is strictly prohibited without expressed written permission from the owner.
Custom Search