Table of Contents
- 2The size of the thing
- 3About the measurements used
- 4A visual index
- 5Overview of the head
- 6Step 1.1. The head side-frames.
- 7Step 1.2. The head inner support structure.
- 8Step 1.3. The form (mold) for the hypertufa.
- 9Step 1.4. Hypertufa
- 10Placing the hypertufa
- 11Hypertufa - The curing process
- 12Step 1.5. Slurry
- 13Off with the formwork
- 14Step 1.6. The head side-covers and the crown
- 15The crown
- 16Fixing the trim to the side-covers
- 17Step 1.7. Fiberglass
- 18Step 1.8. Paint - undercoating the head
- 19Overview of the body frame
- 20Step 2.1. Shaping the frame members
- 21Step 2.2. Cutting the frame members to length
- 22Step 2.3. Making the wall frames
- 23Step 2.4. The body frame
- 24Step 2.5. The shackles
- 25Overview of the Neck
- 26Step 3.1. The neck - making the box unit
- 27Step 3.2. The aluminum angle for the sign
- 28Step 3.3. Internal perimeter pieces
- 29Step 3.4. Fitting the neck
- 30Step 3.5. The telephone sign
- 31Step 4.1. The trim around the door and window openings
- 32Door and window overview and plan
- 33Step 4.2. Wood for the door and windows
- 34Step 4.3. Joining the stiles and rails
- 35Step 4.4. Notching the muntin bars
- 36Step 4.5. Fixing the muntin bars
- 37Step 4.6. Painting the door and windows
- 38Step 4.7. The acrylic sheet
- 39Step 5.1. Making the base
- 40Step 5.2. Some painting
- 41Step 6.1. Putting it all together
- 42Some strengthening and the door closer
- 43The desired effect
- 44Step 7.1. The rose and ceiling
- 45Making the rose pattern
- 46Marking, drilling, and cutting the rose
- 47Tapering the rose
- 48Painting and fitting the ceiling and rose
- 49The light goes on
- 50The plans
Chapter 2: The Body Frame
Overview of the body frame
The K2 is adorned with a few decorative Having alternating ridges and grooves. type trims that run around the outside of the frame.
Because I was unable to source any such lookalike Timber, lumber. The hard fibrous lignified substance under the bark of trees, I shaped my own out of 2″ x 4″ (100mm x 50mm).
I was able to make the ‘corrugated’ frame members using just a standard circular saw, a planer, and sand paper.
The rest of the material required for the body frame was easy enough to obtain from building supply stores.
In all, the body frame consisted of 2″x4″ (100mm x 50mm) wood for the framing members (the pieces with the corrugated bits), 11/16″ (18mm) A piece of wood made of three or more layers of wood veneer laminated together with glue. for the floor and back wall, and some quarter-round for up the corners and around the top.