Table of Contents
- 1Introduction
- 2About the measurements, wood sizes
- 3The materials (shopping) list
- 4The materials (shopping) list continued
- 5The cutting list
- 6Cut, shape, and drill the pieces
- 7 Plans, the individual frame pieces
- 8Make up the smaller side frames
- 9Fix the seat support pieces to the long legs
- 10Assemble the side frames
- 11Prepare the frames for seat and tabletop
- 12Make the seat and tabletop panels
- 13Fix and seats and tabletop
- 14Adjust the backstops and fix the bracing
- 15Plans - the armrest
- 16Make and fit the armrest frames
- 17Make and fit the armrest pads
- 18Make the umbrella hole and more photos
Prepare the frames for seat and tabletop
Step 7. Fold the side frames over to seat position.
Fold the side frames over until the tops of the horizontal seat members [d], [g], and [j] are flush (even), and then apply a clamp to each side frame to hold it in that position.
Then place the side frames apart and parallel in readiness for the seats and tabletop.
Follow the sequence of pictures below.
Follow the sequence of pictures below.
For the frame I used 5/4 x 6 pressure treated wood (actual 1.25 x 5.5). I don’t have a power miter saw so I cut each length with a circular saw then ripped into two identical pieces with a table saw. Cut the angles for each piece with a table saw. The top and seats are T&G pine. This may not hold up outside so I didn’t glue them. I can always replace them with the same pressure treated wood. If I do this I will edge dowel them together rather than use a rod or a batten as shown in the plans.
Thanks for the plans.
Reed
Beware – the cut list is converted to English units by dividing by 25, resulting in rounding errors. More accurate English units can be obtained by dividing by 25.4.