Table of Contents
- 1Introduction and Informative Stuff
- 2Plan Drawings and a Material List
- 3Making the floor
- 4Making the front and rear wall frames
- 5Making the curved members
- 6Making the side wall frames
- 7Marking the plywood wall panels
- 8Cutting and preparing the roof frame
- 9Painting the wall frames and panels
- 10Fixing the wall panels to the frames
- 11Putting the floor in place
- 12Standing the walls
- 13Assembling the roof frame
- 14Covering the roof
- 15Making the door
- 16Making the window
- 17Installing the door and the window
- 18The drip caps
- 19A few help notes for the Tudor Shed project
Fixing the wall panels to the frames
Section 10.1. Positioning the wall panels
Note that the wall-panels for the front and rear frames do not sit Being even with. with the sides of the frames.
They are in from the sides 2 1/4″ (63mm), which is the thickness of a frame Piece of lumber that is part of a frame or structure. plus the thickness of the A piece of wood made of three or more layers of wood veneer laminated together with glue..
When you lay the front and rear wall frames on a flat surface in readiness for the panels, pencil a line down each side of each frame, 2 1/4″ (63mm) in from the edge.
That will give you a line to align the wall-panels to.
In other words, the panels will be off-set 2 1/4″ (63mm) in from the side edges of the frame.
Section 10.2. Cutting away the door-fame The bottom horizontal framing member of the wall.
Cut out the bottom The top or bottom horizontal framing member of the wall. in the doorway and replace it with a temporary To make rigid. fixed to the underside of the plate, each side of the doorway, so the frame cannot spread out or close in until such time as it is ready to be securely fixed in place.
Section 10.3. A plywood sheet or any part of, used for the wall cladding. nailing detail
A short nail with a large flat head used for securing roofing felt, plasterboard, sheet metal to wood etc. the sheets to the frame members with 2 1/2″ (60mm) Covered with a protective coating of zinc. flathead nails spaced at a maximum of 6″ (150mm).